Reply to thread

Message: <blockquote data-quote="fanzyboy234" data-source="post: 7981305" data-attributes="member: 648518"><p>Ok well i just got my new boss ph 2.800 1600 watt max amp and i hooked my dvc 4 ohm subs up that are wired at 2 ohms and it keeps putting my amp into protection mode.  So i took a voltmeter and tested my subs. One of them reads about 2 ohms (1.8) and the other reads (0.2) so i took all the wiring off of the one that reads 0.2 and used the voltmeter and each voice coil reads about 4 ohms (3.8) so that should mean my sub isn't blown up but i rewired and retested for 2 ohms 4 times and still get the same results (0.2).  I cannot figure out what the problem is.  My amp will work with a 2 ohm load also.  Anyone know what the problem could be?</p></blockquote><p></p>

Top