Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Stuck in protection mode with factory headunit and lc2i
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="keep_hope_alive" data-source="post: 8658268" data-attributes="member: 576029"><p>Please verify the protection mode you refer to is the light on the amp. </p><p></p><p>If the amp does not go into protection with the subs disconnected, then the problem is the wiring in the box (most likely). Even one strand of wire can short out and cause this.</p><p></p><p>If the amp goes into protection without the subs disconnected, then the problem is in the amp. </p><p></p><p>Pic or share the LOC settings? Are you generating a turn-on signal from signal sense (auto turn on)? Confirm the stock system is turned on during these tests.</p><p></p><p>Where did you get an audio signal from? What factory speakers did you intercept? </p><p></p><p>The factory amp power wiring is probably pretty small, confirm your amp has a dedicated run of power wire (4awg) ran to the battery (and fused at the battery). </p></blockquote><p></p>
[QUOTE="keep_hope_alive, post: 8658268, member: 576029"] Please verify the protection mode you refer to is the light on the amp. If the amp does not go into protection with the subs disconnected, then the problem is the wiring in the box (most likely). Even one strand of wire can short out and cause this. If the amp goes into protection without the subs disconnected, then the problem is in the amp. Pic or share the LOC settings? Are you generating a turn-on signal from signal sense (auto turn on)? Confirm the stock system is turned on during these tests. Where did you get an audio signal from? What factory speakers did you intercept? The factory amp power wiring is probably pretty small, confirm your amp has a dedicated run of power wire (4awg) ran to the battery (and fused at the battery). [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Stuck in protection mode with factory headunit and lc2i
Top
Menu
Home
Refresh