Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Static noise from speakers and front speakers popping/clipping after the amp install?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Falloutkid90" data-source="post: 8060475" data-attributes="member: 645542"><p>So I've been running a set of kicker ks series speakers and two kicker comps. I've had a kicker zx350.4 amp I've been wanting to install but havent had the chance. I wired everything up fine (two distribuition blocks, 4 and 8 ga wire, rcas', ect.) Both amps power on fine when I turn on my radio. The sun was starting to go down so I only had a chance to wire my rear speakers since the amp is in the trunk. I ran each speaker to one channel. When I put on some music and crank the volume past 10 (out of 40) the front speakers start popping/clipping like crazy and no matter what volume their is static from the rear amped speakers and it sounds like crap (better off with hu power). What could be causing this? The amped speakers have not properly connected (no solder), but they are still connected my grounds are sanded and my other connection are tight. I can put a picture up of the set up tomorrow if need be.</p></blockquote><p></p>
[QUOTE="Falloutkid90, post: 8060475, member: 645542"] So I've been running a set of kicker ks series speakers and two kicker comps. I've had a kicker zx350.4 amp I've been wanting to install but havent had the chance. I wired everything up fine (two distribuition blocks, 4 and 8 ga wire, rcas', ect.) Both amps power on fine when I turn on my radio. The sun was starting to go down so I only had a chance to wire my rear speakers since the amp is in the trunk. I ran each speaker to one channel. When I put on some music and crank the volume past 10 (out of 40) the front speakers start popping/clipping like crazy and no matter what volume their is static from the rear amped speakers and it sounds like crap (better off with hu power). What could be causing this? The amped speakers have not properly connected (no solder), but they are still connected my grounds are sanded and my other connection are tight. I can put a picture up of the set up tomorrow if need be. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Static noise from speakers and front speakers popping/clipping after the amp install?
Top
Menu
Home
Refresh