Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Static and popping upon turning off
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Xcedrin" data-source="post: 8741056" data-attributes="member: 682618"><p>Hey Guys Need some help.</p><p></p><p>Installed new system, amp, hu, components, and sub. Everything seemed to be running fine for awhile. I left the amp unsecured to set gain then establish a better ground othen then the seat bolt and shorten some cables to tidy up amp wire mess. Worked ok but I was getting noise from left rear speaker only. Seemed to have vanished and worked well for a bit.</p><p></p><p>Well Sunday I pulled out the seat. Took my ground wire and hooked it up to the solid frame underneath my 4runner. Hooked everything back up powered on and buzz from one speaker right front. Unplugged speaker cable sound continued. Unplugged rca sound went away. Swapped this withe a different speaker from same result only one speaker though. Turning it off only one speaker will pop and I can move it around based on where the rca cable is inputted. OK I thought I had pinpointed it to an RCA cable.... Swapped the cable to a brand new one avoiding being close to the power run. Plugged it in.... same result popping and light static noise same speaker as other rca run just the ONE. I did make the mistake of running all my rca cables the same route as the power cable as are the new speaker wires. I have tried looping wire around all rca inputs and grounding it to something close but same result. Im not sure what to try next other then re route the positive cable from the battery but im not sure why this would cause a sudden issue now.</p><p></p><p>Any help here?</p><p></p><p>Hu Avh2550 nex</p><p>Amp - pdx v9</p><p>Kappa 6.5 compont</p><p>Jl 10w3v3</p></blockquote><p></p>
[QUOTE="Xcedrin, post: 8741056, member: 682618"] Hey Guys Need some help. Installed new system, amp, hu, components, and sub. Everything seemed to be running fine for awhile. I left the amp unsecured to set gain then establish a better ground othen then the seat bolt and shorten some cables to tidy up amp wire mess. Worked ok but I was getting noise from left rear speaker only. Seemed to have vanished and worked well for a bit. Well Sunday I pulled out the seat. Took my ground wire and hooked it up to the solid frame underneath my 4runner. Hooked everything back up powered on and buzz from one speaker right front. Unplugged speaker cable sound continued. Unplugged rca sound went away. Swapped this withe a different speaker from same result only one speaker though. Turning it off only one speaker will pop and I can move it around based on where the rca cable is inputted. OK I thought I had pinpointed it to an RCA cable.... Swapped the cable to a brand new one avoiding being close to the power run. Plugged it in.... same result popping and light static noise same speaker as other rca run just the ONE. I did make the mistake of running all my rca cables the same route as the power cable as are the new speaker wires. I have tried looping wire around all rca inputs and grounding it to something close but same result. Im not sure what to try next other then re route the positive cable from the battery but im not sure why this would cause a sudden issue now. Any help here? Hu Avh2550 nex Amp - pdx v9 Kappa 6.5 compont Jl 10w3v3 [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Static and popping upon turning off
Top
Menu
Home
Refresh