Reply to thread

Message: <blockquote data-quote="Boomin_tahoe" data-source="post: 3097991" data-attributes="member: 562180"><p>Ok here's what I did. Took the subs out of the box. Checked my wiring....and it's good. Didn't notice out of phase, or a wire dropped someplace. Saw that it wasn't getting a good seal so I sanded the lifted areas where the mounting screw holes are, put a better seal around them, and screwed the subs back into place. Fired them up....annndd....nothing. Went back to the drawing design, done by Chris Marshall, just to see if I goofed some place and noticed a piece of corner/bracing that I missed during the enclosure build. Would this have any affect on it at all?? The piece goes in the corner near the sub, and has 45 degree angle cuts on each side. And again I pushed on one of the subs inward and still got better sound than if I didn't. I have no idea what's goin on. Now I'm thinkin' it might be the enclosure.</p></blockquote><p></p>

Top