Reply to thread

Message

<blockquote data-quote="Moble Enclosurs" data-source="post: 7475491" data-attributes="member: 634917">I want to make sure that you know, the reason it yielded the best results is due to the enclosure they were previously in. This can change upon the design, so my recommendation is to explore the possibility of using slot ports as well, and if that is not a possibility, then I can look at your design specs and figure something more accurate for you if you like. But, keep in mind that there will always exist some limitations, and going for that low of a tuning may be improbable for what you are asking for, not sure yet. Because for 2 cubic ft, especially in separate chambers(which is why I recommended a common chamber) will be tough to get that low of tuning properly without decreasing the area of your ports, which I would not recommend due to the noise factor involved after what I had calculated for a minimum area.So, I can either request that you purchase a design from myself or others, or let me do some little bit of free math for you to get something more probable. Sound reasonable?</blockquote>

[QUOTE="Moble Enclosurs, post: 7475491, member: 634917"] I want to make sure that you know, the reason it yielded the best results is due to the enclosure they were previously in. This can change upon the design, so my recommendation is to explore the possibility of using slot ports as well, and if that is not a possibility, then I can look at your design specs and figure something more accurate for you if you like. But, keep in mind that there will always exist some limitations, and going for that low of a tuning may be improbable for what you are asking for, not sure yet. Because for 2 cubic ft, especially in separate chambers(which is why I recommended a common chamber) will be tough to get that low of tuning properly without decreasing the area of your ports, which I would not recommend due to the noise factor involved after what I had calculated for a minimum area. So, I can either request that you purchase a design from myself or others, or let me do some little bit of free math for you to get something more probable. Sound reasonable? [/QUOTE]

Verification