Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Speakers not pushing enough power.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Popwarhomie" data-source="post: 8759769" data-attributes="member: 619389"><p>If they get louder while using your phone over the headunit then it's a headunit RCA voltage problem. I have no experience with that headunit but from what they say it has 4 volt rca outputs. There could be a setting on the headunit to raise RCA output level.</p><p></p><p>The dyno video for that amp shows it did 200 watts at 2 ohms. Three 8 ohm powerhorns would be a 2.67 ohms so even less power.</p><p></p><p></p><p>On the amp do you have the sensitivity switch at "2-8 volt" sensitivity setting or "100mv-2v"?</p></blockquote><p></p>
[QUOTE="Popwarhomie, post: 8759769, member: 619389"] If they get louder while using your phone over the headunit then it's a headunit RCA voltage problem. I have no experience with that headunit but from what they say it has 4 volt rca outputs. There could be a setting on the headunit to raise RCA output level. The dyno video for that amp shows it did 200 watts at 2 ohms. Three 8 ohm powerhorns would be a 2.67 ohms so even less power. On the amp do you have the sensitivity switch at "2-8 volt" sensitivity setting or "100mv-2v"? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Speakers not pushing enough power.
Top
Menu
Home
Refresh