Reply to thread

Message: <blockquote data-quote="tdawg30" data-source="post: 2538536" data-attributes="member: 572527">hell make ur own. I just made some 6.5s fit in where my 4x6s were so it can be done. just use the half in and it should raise it enough to where your magnet and all other diameters shouldnt matter since the hole before it was 5 in in diameter. unless u have beefed up 6.5s with a 5in diam magnet then ur ok. trust me it should work, and if not then whats a whole 10 minutes wasted making the rings instead of paying 18+ for somethin else you dont even know will work.I had to do some cutting with the dremel but it was well worth it. go out and be a craftsman!!!!!!!!!!!</blockquote>

Top