I just set up my audiopipe acpl15001d amp and everything was good until I was driving and my subs werent playing . I stopped to check it out, and my positive and negative was touching. It was probably touching for a good minute. When i separated the two wires the subs made a loud BOOM then the amp went into protect mode and now the power light flickers and theres a clicking noise coming from the power cable into the amp. There are no fuses on this amp. What could be the problem? I let the amp click for a minute and felt the board and it was getting hot.
Activity
No one is currently typing a reply...
Similar threads
Dammned good speakers. Just pass up the CL series,and you will be pleased with CDT speakers. I still enjoy all mine. Polk MM series and Infinity...
- Started by Kanewpadle
- Speakers
Yes. Only thing is the leads will be encased in resin.
Keep in mind that this is an assumption.
- Started by 1slow77
- General Car Audio
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
- Started by kanihoncho
- Speakers
Thanks again have a good weekend . . . .
- Started by kanihoncho
- Speakers
About this thread
New threads
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 0
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2
-
Yamaha Ypa-700!Scored this on ebay. Listed as untested. They accepted my...- Started by metalheadjoe
- Replies: 1
-
Do I need maestro?I am looking to replace the factory head unit on my wife's...- Started by ncted
- Replies: 1