Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker Distortion after new installation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Dragon56" data-source="post: 8652491" data-attributes="member: 675429"><p>Hi Folks,</p><p></p><p>I just installed a new Pioneer head unit Model DEH- S6000BS in my Motorhome. The existing speakers</p><p></p><p>are mounted front and rear of the cabin. The original cassette player had only three pairs of speaker wires. After tracing out all of the wires I found that each speaker has one separate wire, but each side ( left and right pair ) has a common wire. The wiring diagram on the new deck shows each speaker with two separate wires to each speaker. Once I connected the speakers using only the wires I had I found that I have major distortion at volumes over 20. All of the speakers sound the same and none are worse or better than the others. Is it possible that I will have to run a separate pair dedicated to each speaker?</p><p></p><p>Any Advice?</p><p></p><p>Thanks</p><p></p><p>Dragon56</p></blockquote><p></p>
[QUOTE="Dragon56, post: 8652491, member: 675429"] Hi Folks, I just installed a new Pioneer head unit Model DEH- S6000BS in my Motorhome. The existing speakers are mounted front and rear of the cabin. The original cassette player had only three pairs of speaker wires. After tracing out all of the wires I found that each speaker has one separate wire, but each side ( left and right pair ) has a common wire. The wiring diagram on the new deck shows each speaker with two separate wires to each speaker. Once I connected the speakers using only the wires I had I found that I have major distortion at volumes over 20. All of the speakers sound the same and none are worse or better than the others. Is it possible that I will have to run a separate pair dedicated to each speaker? Any Advice? Thanks Dragon56 [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Speaker Distortion after new installation
Top
Menu
Home
Refresh