Reply to thread

Message

<blockquote data-quote="xguntherc" data-source="post: 6473006" data-attributes="member: 605519">Hey everyone. I&#039;m getting ready to start the next part of my build here. I have got everything ready to amp my 4 doors and my sub is all up n running.So. I was hoping for any advice, or pointers on doing the install and wiring for the 4 doors. I&#039;ve done more than a few sub installs, but never done my 4 doors and amplified it. So I have an Ext. Cab truck and I was thinking I&#039;d unplug the old and stock speaker cables, n leave them ran the way they are, cover the ends and tape them down securely. This way if I sell the car in the future I can remove my door speakers, or even sell em with it and rewire it for the HU easily. Make sense?So if I do that do I also need to pull them out of the HU back. Or if they are not plugged into the speakers am I ok to just leave them alone?? Afterall the new wires go to amp.&nbsp; From there I&#039;ll run my new wires n all to my amp and I&#039;m probably ok with the rest.I do have some dynamat, I add that to the door wall, behind the speaker right?? I might dyno the doors cuz I have a spare box.Thanks, n feel free to give any pointers or suggestions on the install procedure for the door speakers amplification. I&#039;ve already got the alpine type S installed</blockquote>

[QUOTE="xguntherc, post: 6473006, member: 605519"] Hey everyone. I'm getting ready to start the next part of my build here. I have got everything ready to amp my 4 doors and my sub is all up n running. So. I was hoping for any advice, or pointers on doing the install and wiring for the 4 doors. I've done more than a few sub installs, but never done my 4 doors and amplified it. So I have an Ext. Cab truck and I was thinking I'd unplug the old and stock speaker cables, n leave them ran the way they are, cover the ends and tape them down securely. This way if I sell the car in the future I can remove my door speakers, or even sell em with it and rewire it for the HU easily. Make sense? So if I do that do I also need to pull them out of the HU back. Or if they are not plugged into the speakers am I ok to just leave them alone?? Afterall the new wires go to amp. From there I'll run my new wires n all to my amp and I'm probably ok with the rest. I do have some dynamat, I add that to the door wall, behind the speaker right?? I might dyno the doors cuz I have a spare box. Thanks, n feel free to give any pointers or suggestions on the install procedure for the door speakers amplification. I've already got the alpine type S installed [/QUOTE]

Verification