Reply to thread

Message

<blockquote data-quote="azbass" data-source="post: 2479557" data-attributes="member: 557015">try this99 grand am.....Transmitter Programming:1)With the driver door closed, hold down the power unlock button on the door panel.2)Turn the ignition switch to the ON position3)Turn the ignition switch to the OFF position4)Turn the ignition switch to the ON position5)Turn the ignition switch to the OFF position6)Release the power unlock button on the door panel.The remote control door lock reciever will respond in the following manner in order to indicate that the receiver is in the programming mode:6.1)Locking the doors6.2)Unlocking the doorsIMPORTANT:All extra transmitters must be programmed at this time. When a new transmitter is programmed it will deactivate the old transmitters.7)Hold down the lock and unlock buttons on the transmitter until the remote control door lock reciever will respond in the following manner:7.1)Locking the doors7.2)Unlocking the doorsRepeat step 7 for each additional transmitter9) Turn the ignition switch to the ON position in order to exit the transmitter programming mode.</blockquote>

[QUOTE="azbass, post: 2479557, member: 557015"] try this 99 grand am..... Transmitter Programming: 1)With the driver door closed, hold down the power unlock button on the door panel. 2)Turn the ignition switch to the ON position 3)Turn the ignition switch to the OFF position 4)Turn the ignition switch to the ON position 5)Turn the ignition switch to the OFF position 6)Release the power unlock button on the door panel. The remote control door lock reciever will respond in the following manner in order to indicate that the receiver is in the programming mode: 6.1)Locking the doors 6.2)Unlocking the doors IMPORTANT: All extra transmitters must be programmed at this time. When a new transmitter is programmed it will deactivate the old transmitters. 7)Hold down the lock and unlock buttons on the transmitter until the remote control door lock reciever will respond in the following manner: 7.1)Locking the doors 7.2)Unlocking the doors Repeat step 7 for each additional transmitter 9) Turn the ignition switch to the ON position in order to exit the transmitter programming mode. [/QUOTE]

Verification