Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Sketchup Practice...give me your preferred net volume and tuning frequency
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="slikrider20" data-source="post: 8612957" data-attributes="member: 563044"><p>One thing i'm not for certain though...when designing the box for port length, I measured from the middle of both port pieces all the way down. That's what the 13.25" and 11.75" measurements are...which is 25" combined. But, for the end correction, I read somewhere that you take half of the port width and take that from the length. Do you have to add that to the length or subtract it? I subtracted it in this example for the 26" requested length but I wasn't completely sure on that. Although i'm sure the difference wouldn't even be audible.</p></blockquote><p></p>
[QUOTE="slikrider20, post: 8612957, member: 563044"] One thing i'm not for certain though...when designing the box for port length, I measured from the middle of both port pieces all the way down. That's what the 13.25" and 11.75" measurements are...which is 25" combined. But, for the end correction, I read somewhere that you take half of the port width and take that from the length. Do you have to add that to the length or subtract it? I subtracted it in this example for the 26" requested length but I wasn't completely sure on that. Although i'm sure the difference wouldn't even be audible. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Sketchup Practice...give me your preferred net volume and tuning frequency
Top
Menu
Home
Refresh