I just added a sirius receiver CR-SRT100 to a Panasonic cq-vad7300u. The only thing it will do is display "acquiring signal." I tried to activate it, but Sirius cannot do it until I receive a signal. I am not near any buildings or large objects. I tried to drive to different parts of the town. I have an antenna with a single wire, and a splitter. I swapped out the antenna and receiver with new ones and still no change. Our other options are the wire harness and the splitter. I was just checking if any one has seen this before. Thank you
About this thread
New threads
-
No sound on new additionI have an Alpine Aix w650 Bluetooth headset with backup cam...- Started by Scott B.
- Replies: 0
-
Old School BuildI had to remove this old school build a couple of days ago...- Started by Bobbytwonames
- Replies: 0
-
Drilling through carpetWhen I install my amp rack in my Caddy I will need to drill...- Started by maylar
- Replies: 3
-
New audio setup has a BUZZI am relatively new to car audio and was originally quite...- Started by Corsair714
- Replies: 8
-
FEATURED Aftrmarket Android 10 with DSP build in (mazda 6 skyactiv 2017) interference problem AUX IN -NOT OUTPUT! (no whine noise or engine rpm)Hello all. At the beggining i would like to apologize for too...- Started by JustAguy39
- Replies: 0