Reply to thread

Message

<blockquote data-quote="EAD" data-source="post: 3078042" data-attributes="member: 577750">Hello all,I am new here, but I plan to stick around... finally got my amp out of protection mode after a faultly installation by a local audio-shop. I think I&#039;ll stick to what I know and the hobbiest heres knowledge.Finally I was able to get everything going, but now I need to set everything and the guides I found are beyond on comprehension.I have Audiobahn A1200N Head Unit, Audiobahn A2381T and two 12&quot; Audiobahn subs. I forget the model number, but they are from about 2002, and are rated 1200W RMS each, true or not the amp isn&#039;t too powerful.The amp outputs are,Amplifier Type: 2-channelRMS Power @ 4 Ohms: 200W x 2THD at 4-Ohm RMS Power: 0.02%Bridged RMS Power @ 4 Ohms: 560W x 1 @ 2 OhmsSpeaker Level Inputs: noPreamp Outputs: yesBuilt-In Crossovers: HP/LPBass Boost: 0-18 dBFrequency Response: 10-40,000 HzSignal to Noise Ratio: &amp;gt; 100 dBBasically, I need to know, how fair gain should be up approx, and bass boost yes or no and and approx of sub sonic freq.&nbsp; From there&nbsp; I should be able to adjust the lpf and hpf by the audio files and by ear.&nbsp; The above are the confusing parts to me. I will also turn everything off and flat on the head unit.Thanks all, I look foward to being hereEd</blockquote>

[QUOTE="EAD, post: 3078042, member: 577750"] Hello all, I am new here, but I plan to stick around... finally got my amp out of protection mode after a faultly installation by a local audio-shop. I think I'll stick to what I know and the hobbiest heres knowledge. Finally I was able to get everything going, but now I need to set everything and the guides I found are beyond on comprehension. I have Audiobahn A1200N Head Unit, Audiobahn A2381T and two 12" Audiobahn subs. I forget the model number, but they are from about 2002, and are rated 1200W RMS each, true or not the amp isn't too powerful. The amp outputs are, Amplifier Type: 2-channel RMS Power @ 4 Ohms: 200W x 2 THD at 4-Ohm RMS Power: 0.02% Bridged RMS Power @ 4 Ohms: 560W x 1 @ 2 Ohms Speaker Level Inputs: no Preamp Outputs: yes Built-In Crossovers: HP/LP Bass Boost: 0-18 dB Frequency Response: 10-40,000 Hz Signal to Noise Ratio: > 100 dB Basically, I need to know, how fair gain should be up approx, and bass boost yes or no and and approx of sub sonic freq. From there I should be able to adjust the lpf and hpf by the audio files and by ear. The above are the confusing parts to me. I will also turn everything off and flat on the head unit. Thanks all, I look foward to being here Ed [/QUOTE]

Verification