Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Builds
Car Audio Build Logs
Silverado DDZ build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="adulbrich" data-source="post: 8429117" data-attributes="member: 661255"><p>It's to hold the wire, so its weight doesn't pull it out of the amp input.</p><p></p><p>Yep, almost done.</p><p></p><p>Here's what I need to do, in no particular order. (still quite a lot, actually)</p><p></p><p>1. Mount mids/highs in doors</p><p></p><p>2. Treat doors and run wires back to the amp</p><p></p><p>3. Protect positive wire going through the bed</p><p></p><p>4. Install alternator with the bracket and run power/ground wires to the battery bank</p><p></p><p>5. Get recones and build the subs</p><p></p><p>6. Finish coating the inside of the box with resin and brace it</p><p></p><p>7. Cut sub holes and add length to the port</p><p></p><p>8. Mount subs and wire them up</p><p></p><p></p><p>Ok</p></blockquote><p></p>
[QUOTE="adulbrich, post: 8429117, member: 661255"] It's to hold the wire, so its weight doesn't pull it out of the amp input. Yep, almost done. Here's what I need to do, in no particular order. (still quite a lot, actually) 1. Mount mids/highs in doors 2. Treat doors and run wires back to the amp 3. Protect positive wire going through the bed 4. Install alternator with the bracket and run power/ground wires to the battery bank 5. Get recones and build the subs 6. Finish coating the inside of the box with resin and brace it 7. Cut sub holes and add length to the port 8. Mount subs and wire them up Ok [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Builds
Car Audio Build Logs
Silverado DDZ build
Top
Menu
What's new
Forum list
