Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Shopping for a AMP, but...............
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Slap_my_momma" data-source="post: 6614459" data-attributes="member: 618429"><p>I am looking to spend ruffly about $175.00</p><p></p><p>The two amps I am looking @ are:</p><p></p><p>AutoTek AT1500 &amp; Power Acoustik LFA2-1800</p><p></p><p>From my understanding and reading about Ohm loads.</p><p></p><p>I can have (2) 4-ohm subs, then run on each sub (-) to each other then the (+) to each other then on a amp, if it is 2-ohm stable, I put the (-) to the amp (mono/bridge) (-) and the (+) on the (+) on the amp (mono/bridge) and it will make both my subs go into a 2-ohm load. Is this correct??</p><p></p><p>Like this:</p></blockquote><p></p>
[QUOTE="Slap_my_momma, post: 6614459, member: 618429"] I am looking to spend ruffly about $175.00 The two amps I am looking @ are: AutoTek AT1500 & Power Acoustik LFA2-1800 From my understanding and reading about Ohm loads. I can have (2) 4-ohm subs, then run on each sub (-) to each other then the (+) to each other then on a amp, if it is 2-ohm stable, I put the (-) to the amp (mono/bridge) (-) and the (+) on the (+) on the amp (mono/bridge) and it will make both my subs go into a 2-ohm load. Is this correct?? Like this: [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Shopping for a AMP, but...............
Top
Menu
What's new
Forum list
