Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
seperating coax's?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="2000JEEP" data-source="post: 5958303" data-attributes="member: 610032"><p>could i seperate 2 sets of 2 ways and parallel wire the midbass's together and tweeters together to achieve a 2 ohm load at the amp with the correct x-over points</p><p></p><p>I am trying to run four 2 ohm channels with a set of alpine coax's and a set of comps</p><p></p><p>i figured if i could remove the tweets from the coax's and wire parallel with the comp tweets and same for the mids i'd be able to run 2 ohms to the amp</p><p></p><p>anyone ever tried this?</p></blockquote><p></p>
[QUOTE="2000JEEP, post: 5958303, member: 610032"] could i seperate 2 sets of 2 ways and parallel wire the midbass's together and tweeters together to achieve a 2 ohm load at the amp with the correct x-over points I am trying to run four 2 ohm channels with a set of alpine coax's and a set of comps i figured if i could remove the tweets from the coax's and wire parallel with the comp tweets and same for the mids i'd be able to run 2 ohms to the amp anyone ever tried this? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
seperating coax's?
Top
Menu
What's new
Forum list
