Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Running Taramps below rated load (1 or .5 ohm)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="nate0" data-source="post: 8673051" data-attributes="member: 674948"><p>Like stated I am more specifically asking about running the 2ohm model (md series I guess) at around 1ohm. And honestly I am only asking this out of curiosity. It would seem more logical to run a 2ohm Taramps at 1ohm to get the power of a 1ohm model at the same resistance depending on how your subs clamp the power and all. Running those taramps high voltage circuits especially the entry level ones at .5 or around there impedance load is crazy.</p><p></p><p>EDIT: Actually I realized what I was looking for. Thanks for sharing what you know about them and what you have seen. </p></blockquote><p></p>
[QUOTE="nate0, post: 8673051, member: 674948"] Like stated I am more specifically asking about running the 2ohm model (md series I guess) at around 1ohm. And honestly I am only asking this out of curiosity. It would seem more logical to run a 2ohm Taramps at 1ohm to get the power of a 1ohm model at the same resistance depending on how your subs clamp the power and all. Running those taramps high voltage circuits especially the entry level ones at .5 or around there impedance load is crazy. EDIT: Actually I realized what I was looking for. Thanks for sharing what you know about them and what you have seen. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Running Taramps below rated load (1 or .5 ohm)
Top
Menu
Home
Refresh