Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Rockford Power T1000-1BDCP mono amp for sub?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="BlackHawk99" data-source="post: 7704816" data-attributes="member: 640618"><p>Thanks for the reply! I have just slight head light dimming at times (not all the time) and I mean very very slight dimming with the T600-4. If I would get the T1000 for the sub(s) I would then only being using 2 channels from the T600-4 for the fronts. Two channels would be wasted. Would that lessen the electrical system strain? I thought this class D mono amp would be the ticket after reading they are very efficient. I would not run this amp at 1 ohm. I wouldn't take it below 2 ohm. Does that factor in and put less of a strain? Thanks buddy. BTW, I looked at my amp gains again and I was looking at the dial wrong. LOL! Thanks for your help with that as well!</p></blockquote><p></p>
[QUOTE="BlackHawk99, post: 7704816, member: 640618"] Thanks for the reply! I have just slight head light dimming at times (not all the time) and I mean very very slight dimming with the T600-4. If I would get the T1000 for the sub(s) I would then only being using 2 channels from the T600-4 for the fronts. Two channels would be wasted. Would that lessen the electrical system strain? I thought this class D mono amp would be the ticket after reading they are very efficient. I would not run this amp at 1 ohm. I wouldn't take it below 2 ohm. Does that factor in and put less of a strain? Thanks buddy. BTW, I looked at my amp gains again and I was looking at the dial wrong. LOL! Thanks for your help with that as well! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Rockford Power T1000-1BDCP mono amp for sub?
Top
Menu
Home
Refresh