Rockford Fosgate EPX2 with 28 band EQ card, non-working

SPL Blazer
10+ year member

SPL Event Promoter
Rating: 0%
0 0 0
What I have here is the Rockford Fosgate EPX2 X-Over and Line Driver With 28 band EQ card. It powers on fine, but stopped receiving a signal through the RCA inputs.

Specs:

Expandable Pre-amp and Crossover.

10 channel crossover.

Full preamp.

28 band EQ.

Up to 8 volts output.

RDAT.

Real time adjustments.

Balanced line inputs.

Max Output 10 Vrms (AP).

Max Input 4 Vrms.

Signal to Noise >94dB .

Channel Separation >80dB.

Crossover Type 12dB/octave butterworth.

I had it in my Blazer for a few years and loved it. My only mistake was keeping it too close to my box and it didn't like the vibrations. Unit powers on, but doesn't seem to be getting a signal. Should be easily repairable. I looked at the boards and didn't see anything obvious, but I'm no electronics expert either. I don't plan on running an SQ system any longer, so I have no use for this. These unit's can sell for big money when found with the 28 band EQ card, bought mine for $500 and have seen them for over $800. Comes with everything you see, RDAT controller, special non flipped data cable, power plug and EPX2 unit. I have all the instructions too.

Price: : $350

EPX2.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

SPL Blazer

10+ year member
SPL Event Promoter
Thread starter
SPL Blazer
Joined
Location
Peabody, Massachusetts, United States
Start date
Participants
Who Replied
Replies
2
Views
1,403
Last reply date
Last reply from
SPL Blazer
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top