Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Request: Box plan 1 10" SX ported
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="mobeious" data-source="post: 2176950" data-attributes="member: 554882"><p>Cannot make ports on both ends due to the port would be to small and cause air turbulance so you have to have (1) 2" port on on end of the box || O like that</p><p></p><p>this box is 1.5cubes after all displacment @ 34hz</p><p></p><p>internal dimmentions are 33.5 X 10.5 x 10.5</p><p></p><p>external dimmentions are 35 x 12 x 12</p><p></p><p>overall port length is 28.75"--- the .75 is front face of box</p><p></p><p>here is your cut sheet</p><p></p><p>front - 32.25" x 12"</p><p></p><p>back - 35" x 12"</p><p></p><p>top - 10.5" x 35"</p><p></p><p>bottom - 10.5 x 35"</p><p></p><p>side (non-port) 10.5" x 10.5"</p><p></p><p>side (port) 10.5" x 11.25"</p><p></p><p>port board (1) 10.5" x 8.25"</p><p></p><p>port board (2) 10.5" x 16.25"</p></blockquote><p></p>
[QUOTE="mobeious, post: 2176950, member: 554882"] Cannot make ports on both ends due to the port would be to small and cause air turbulance so you have to have (1) 2" port on on end of the box || O like that this box is 1.5cubes after all displacment @ 34hz internal dimmentions are 33.5 X 10.5 x 10.5 external dimmentions are 35 x 12 x 12 overall port length is 28.75"--- the .75 is front face of box here is your cut sheet front - 32.25" x 12" back - 35" x 12" top - 10.5" x 35" bottom - 10.5 x 35" side (non-port) 10.5" x 10.5" side (port) 10.5" x 11.25" port board (1) 10.5" x 8.25" port board (2) 10.5" x 16.25" [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Request: Box plan 1 10" SX ported
Top
Menu
Home
Refresh