Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Replacing Wire Insulation.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Spaceboy464" data-source="post: 3191388" data-attributes="member: 553571"><p>Long story short: I have a few wires from my factory radio harness that are missing their insulation. My plan was to pull each of the pins out of the factory connector and slide on some heat shrink tubing. I spent the whole day on one pin as they are a pain to get out. Is there an easier way to replace the insulation on these wires? I was thinking I could cut out the section and replace it with some spare wire.</p><p></p><p>Any help is appreciated as I need to finish this by Sunday night. //content.invisioncic.com/y282845/emoticons/verymad.gif.3f39c5c2fd57527b671fad3efdfac756.gif Thanks!</p></blockquote><p></p>
[QUOTE="Spaceboy464, post: 3191388, member: 553571"] Long story short: I have a few wires from my factory radio harness that are missing their insulation. My plan was to pull each of the pins out of the factory connector and slide on some heat shrink tubing. I spent the whole day on one pin as they are a pain to get out. Is there an easier way to replace the insulation on these wires? I was thinking I could cut out the section and replace it with some spare wire. Any help is appreciated as I need to finish this by Sunday night. [IMG]//content.invisioncic.com/y282845/emoticons/verymad.gif.3f39c5c2fd57527b671fad3efdfac756.gif[/IMG] Thanks! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Replacing Wire Insulation.
Top
Menu
What's new
Forum list
