Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Head Units
Remote face plate mounting?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="pattyweb" data-source="post: 2133281" data-attributes="member: 566061"><p>I did something similar to an 880PRS and I can eject my CD but it was a bit of work.</p><p></p><p>1) Did you keep the movable face backplate in place? Is it still going up and down? If so, then I don't know what your issue is except to think that you haven't properly kept the eject wire/pin hooked up.</p><p></p><p>2) Did you remove the motorized mechanism? I did. The trick is that there are 2 wires going to the motor and 3 wires going to the sensor switches that detect whether the face is up or down. I just removed the whole motorized mechanism and tricked the unit into thinking the face is always down (by shorting the two wires that indicated down) and my eject works fine.</p></blockquote><p></p>
[QUOTE="pattyweb, post: 2133281, member: 566061"] I did something similar to an 880PRS and I can eject my CD but it was a bit of work. 1) Did you keep the movable face backplate in place? Is it still going up and down? If so, then I don't know what your issue is except to think that you haven't properly kept the eject wire/pin hooked up. 2) Did you remove the motorized mechanism? I did. The trick is that there are 2 wires going to the motor and 3 wires going to the sensor switches that detect whether the face is up or down. I just removed the whole motorized mechanism and tricked the unit into thinking the face is always down (by shorting the two wires that indicated down) and my eject works fine. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Head Units
Remote face plate mounting?
Top
Menu
Home
Refresh