Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Rebuilding the prototype
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Papermaker85" data-source="post: 8593378" data-attributes="member: 572595"><p>Kmsl. Funny how I went specifically for low Distortion but I use the long Gap long coil topology that has a flatter curve over BL up until the coil leaves the gap. Not only that but i had the coil wound specifically for lower inductance ( if you're so **** smart why don't you tell me what I did). You aren't sharp enough to understand the geometry of the pole piece in relation to the top plate to linearize stroke.</p><p></p><p>Don't start what you can't finish just go ahead and tell me which class doing I'm going to slap two 18s in my car</p></blockquote><p></p>
[QUOTE="Papermaker85, post: 8593378, member: 572595"] Kmsl. Funny how I went specifically for low Distortion but I use the long Gap long coil topology that has a flatter curve over BL up until the coil leaves the gap. Not only that but i had the coil wound specifically for lower inductance ( if you're so **** smart why don't you tell me what I did). You aren't sharp enough to understand the geometry of the pole piece in relation to the top plate to linearize stroke. Don't start what you can't finish just go ahead and tell me which class doing I'm going to slap two 18s in my car [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Rebuilding the prototype
Top
Menu
Home
Refresh