Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Rca outputs/ headunit crossover
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Doxquzme" data-source="post: 8865043" data-attributes="member: 689267"><p>On another note, if you're competing in SPL, you might want to check around at what the best crossover point is. These two drivers (your 6.5s and your bullet tweeters) are very close, efficiency wise so you may get more points on the meter by moving it from the 6k to say 8k. 8k is the limit on the amps filter but I don't know enough about SPL competitions to know what moves the meter. Some might suggest that you remove the LP filter on the 6.5s altogether and let them roll off naturally on the high end, I really don't know what they measure or look for in those SPL competitions. I have recommended the setting in accordance with the tweeter optimal SQL recommendations. I would not go any lower on the tweeter than the 6k as the amp uses only 12db slope, 6K is as low as I would go unless someone in here knows better and can offer a recommendation.</p></blockquote><p></p>
[QUOTE="Doxquzme, post: 8865043, member: 689267"] On another note, if you're competing in SPL, you might want to check around at what the best crossover point is. These two drivers (your 6.5s and your bullet tweeters) are very close, efficiency wise so you may get more points on the meter by moving it from the 6k to say 8k. 8k is the limit on the amps filter but I don't know enough about SPL competitions to know what moves the meter. Some might suggest that you remove the LP filter on the 6.5s altogether and let them roll off naturally on the high end, I really don't know what they measure or look for in those SPL competitions. I have recommended the setting in accordance with the tweeter optimal SQL recommendations. I would not go any lower on the tweeter than the 6k as the amp uses only 12db slope, 6K is as low as I would go unless someone in here knows better and can offer a recommendation. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Rca outputs/ headunit crossover
Top
Menu
Home
Refresh