Reply to thread

Message

<blockquote data-quote="Papermaker85" data-source="post: 8487447" data-attributes="member: 572595">actually its being incresing inport to have a high power factor and a clean signal since the procesing systems(typicall isolated but still the power in coming from the same generator) we use power analizers as well.music is more dynamic as oppsed to say a pipleline pump but something like say as stated a compressor load it is more of a dynamics load. ive sennn the kick on for 2 mintues kick off a minture later kick on.still none the less i brung these conditions out because its a good place to start and if you can use ohms law to get an estimation of the wire thats accpetible.another condition you will see suchs loads are computers and servers(all off short and on alot of equipment now Also another device that would be really similar are varible frequency drives. they use PWM similar to a class D amps. they are used in applitaction suckh as GPS nagivation systems for drill alignment. they keey he rig within 3 feet of the hole.they do this but useing huge electric driver pumps and props to not only maain position but to stablize the rigs yaw and pitch. also the will pump water in and out of the legs(these rigs actually FLOAT) and its all done percisely and very fast.. these are control based applications that are dynaimc loads.</blockquote>

[QUOTE="Papermaker85, post: 8487447, member: 572595"] actually its being incresing inport to have a high power factor and a clean signal since the procesing systems(typicall isolated but still the power in coming from the same generator) we use power analizers as well. music is more dynamic as oppsed to say a pipleline pump but something like say as stated a compressor load it is more of a dynamics load. ive sennn the kick on for 2 mintues kick off a minture later kick on. still none the less i brung these conditions out because its a good place to start and if you can use ohms law to get an estimation of the wire thats accpetible. another condition you will see suchs loads are computers and servers(all off short and on alot of equipment now Also another device that would be really similar are varible frequency drives. they use PWM similar to a class D amps. they are used in applitaction suckh as GPS nagivation systems for drill alignment. they keey he rig within 3 feet of the hole. they do this but useing huge electric driver pumps and props to not only maain position but to stablize the rigs yaw and pitch. also the will pump water in and out of the legs(these rigs actually FLOAT) and its all done percisely and very fast.. these are control based applications that are dynaimc loads. [/QUOTE]

Verification