Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Question on Distortion in New Speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ultimate157" data-source="post: 2585460" data-attributes="member: 566638"><p>When you put those wires together, you are bridging the input from the amp(s), therefore effectively running the mid and high inputs at half their impedance. With a factory system, that impedance requirement could be as high as 8 ohms, and with the bridged wiring you are pulling 2 ohms from each wire.</p><p></p><p>Your best bet is to bypass the factory system and add your own wiring from an aftermarket amp.</p></blockquote><p></p>
[QUOTE="ultimate157, post: 2585460, member: 566638"] When you put those wires together, you are bridging the input from the amp(s), therefore effectively running the mid and high inputs at half their impedance. With a factory system, that impedance requirement could be as high as 8 ohms, and with the bridged wiring you are pulling 2 ohms from each wire. Your best bet is to bypass the factory system and add your own wiring from an aftermarket amp. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Question on Distortion in New Speakers
Top
Menu
What's new
Forum list
