Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Prism, truncated edge box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="dinkaTHEdon" data-source="post: 7817545" data-attributes="member: 642741"><p>So I got a noob question to ask, I don't know how to search it because all that shows up are jig cuts, and I know how to do a jig cut, so here is my question, when I'm cutting the angle of the wood, the table saw only says 0-45 degrees, now it calls for a 108 and 161 degree angle cut on the top and bottom, how do I do this with the table saw, do I subtract it from 180 so I get the other half of the scale? like 180 - 108 = 72? even then I wouldn''t be able to make the cut, because my saw only goes up to 45degrees, SOMEBODY PLEASE HELP ME! I got everything I need now to actually put the box together, and just need this last bit of information so I can get this done, thanks in advanced.</p></blockquote><p></p>
[QUOTE="dinkaTHEdon, post: 7817545, member: 642741"] So I got a noob question to ask, I don't know how to search it because all that shows up are jig cuts, and I know how to do a jig cut, so here is my question, when I'm cutting the angle of the wood, the table saw only says 0-45 degrees, now it calls for a 108 and 161 degree angle cut on the top and bottom, how do I do this with the table saw, do I subtract it from 180 so I get the other half of the scale? like 180 - 108 = 72? even then I wouldn''t be able to make the cut, because my saw only goes up to 45degrees, SOMEBODY PLEASE HELP ME! I got everything I need now to actually put the box together, and just need this last bit of information so I can get this done, thanks in advanced. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Prism, truncated edge box
Top
Menu
Home
Refresh