Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Power Protection, why?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="calebheck" data-source="post: 7208450" data-attributes="member: 630284"><p>hello all!</p><p></p><p>I have a 1000 Watt Kenwood Mono channel amp (KAC-8104D)</p><p></p><p>my step brother let me borrow is two sub box and one kicker comp and I put my sony Xplod in the other side. I had no problems at all, they were just too dang loud.</p><p></p><p>He asked for them back so I decided to install my single Sony Xplod (1200W). I did not change the wiring set up what so ever.</p><p></p><p>The amp went into power protect mode and now I don't know what is wrong. I have even tested all the wires and hooked up nothing but the battery, ground and remote turn on, and it still goes into power protect.</p><p></p><p>My latest thought, possibly the amp is too powerful for a single sub? or the subs Ohm rating is too low?</p></blockquote><p></p>
[QUOTE="calebheck, post: 7208450, member: 630284"] hello all! I have a 1000 Watt Kenwood Mono channel amp (KAC-8104D) my step brother let me borrow is two sub box and one kicker comp and I put my sony Xplod in the other side. I had no problems at all, they were just too dang loud. He asked for them back so I decided to install my single Sony Xplod (1200W). I did not change the wiring set up what so ever. The amp went into power protect mode and now I don't know what is wrong. I have even tested all the wires and hooked up nothing but the battery, ground and remote turn on, and it still goes into power protect. My latest thought, possibly the amp is too powerful for a single sub? or the subs Ohm rating is too low? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Power Protection, why?
Top
Menu
What's new
Forum list
