Reply to thread

Message: <blockquote data-quote="Matador" data-source="post: 166562" data-attributes="member: 545527">you most likely want a distro with one 4 gauge input and 3-4 8gauge outputs. maybe to be in the safe side you could run 2 gauge input, but i think 4 gauge for the input should be enough, by this i mean 4 gauge from teh battery to the distro block (remember to fuse this power wire as close to the battery as you can). then from there you get 3 8gauges n connect to each amp.the size of the fuse would depend on the total fuse that your amps use. if your 1x500 uses a 3x20amps = 60 amps, use a 60 amp fuse, never go bigger cuz it aint good. either get a 60 or a 50amp.then for the remote wire(this is the remote wire from ur hu to the amps that turns amps just when you turn the hu on) you might be able to connect one remote to one amp, n connect to antoher amp from there. not sure bout this someone else might help u with this.</blockquote>

Top