Possible?

[Radioactiv Nuts 10+ year member]

I have a 1993 single cab Ranger. //content.invisioncic.com/y282845/emoticons/verymad.gif.3f39c5c2fd57527b671fad3efdfac756.gif Ivebeen looking at all the possible designs i could put in here. I have a R500-1 amp rated at 576( 8"X16"), im wanting to stick a RF P3 12" in it. But its a rather thick sub 6 3/4". The recommended ported box size is 1.79cu/ft. Thats rather large for my truck. The truck has 60/40 bench seats and the arm is removed. I have about 36" inbetween each rear speaker and 7" from the bottom to the seat. There is a ridge that runs threw the middle of the back of the truck that i plan on cutting out if room is needed. But i would like to hear some input from you guys on if this is the right way to go. Im fairly good at Pro-E and will try to have a sketch posted up soon as i decide on a design. Thanks!//content.invisioncic.com/y282845/emoticons/tongue.gif.6130eb82179565f6db8d26d6001dcd24.gif

Click to read more...

 

[Buck 5,000+ posts]

Do a blow through.

/ your problems with space.

 

[Radioactiv Nuts 10+ year member]

Do a blow through.
/ your problems with space.

A blow through??

 

[Buck 5,000+ posts]

Basically, the subs are in your bed. It's a lot of work, but if you don't mind doing a little cutting in your vehicle.

 

[Buck 5,000+ posts]

Look at this:

http://www.caraudio.com/forum/car-audio-build-logs-cars-trucks-suvs/485913-dodge-ram-build.html

 

[KRYPTO 10+ year member]

I fit 2 12" HE2's in my reg cab ranger.... I just removed the passenger seat //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[Radioactiv Nuts 10+ year member]

I fit 2 12" HE2's in my reg cab ranger.... I just removed the passenger seat //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

I cant really do a blow threw being a daily driver and my only vehicle. Also I cant remove the seat bc i have to carry my sis to school still...i beleive this may work...

 

[Radioactiv Nuts 10+ year member]

This design BARELY fits the rockford p3, im getting the .75 cu/ft and a little left over. The amp will be mounted on in the otherside. I wish i got the R1000.1bd lol its smaller than the r500.1

 

[KRYPTO 10+ year member]

How about putting amp under seat and swapping seats out for bucket seats instead of bench. Then you would have room in center

 

[Radioactiv Nuts 10+ year member]

I have the factory bucket seats but they have a large bracket and a raised bottom leaveing no room, also the amp is large for 500rms. 16"x8'. Its that or the dash

 

[winkychevelle 10+ year member]

its a class ab amp the 1000 is a class d thus the smaller size id try a different sub the p3 isnt worth it sealed

 

[Radioactiv Nuts 10+ year member]

What would you recommend?