Reply to thread

Message: <blockquote data-quote="req" data-source="post: 2463826" data-attributes="member: 555713">the woodburner sounds like it could discolor the plexi, but thats just me assuming. best bet is to print out your design (backwards) and tape it to the plexi, and "trace" your engraving into the plexi using the print as a template.if you want to be neat, you could tape the whole surface of the plexi, and use an xacto knife to cut out the negative areas and sandblast them, then etch with a dremel to get a 3d looking effect.its all about texture. CCFL's are great with plexi, just put it under the edge and try to hide it.</blockquote>

Top