Reply to thread

Message

<blockquote data-quote="smullen" data-source="post: 1386255" data-attributes="member: 549336">Awhile back I did one with a really simmilar shape (bit bigger) in my 2000 Blazer... I took three peices of real thin cardboard or poster board ( 3 becasue of the width) and then took one sheet for each side and slowly cut out a bit at a time till it fit the contour of the trucks interior pretty good...  Once I had each side cut to an acceptable shape, I stapled all three together to make it long eough to be one big sheet...  Then I put the whole thing back in for a final test fit.. When i was happy, I laid that on top of my MDF, using it as a Template, I traced it... Then I cut it out and test fit it again... I made sure the edges were sanded smooth and stretched vinyl over it and covered it.... I think it came out pretty decent for an amateur...</blockquote>

[QUOTE="smullen, post: 1386255, member: 549336"] [SIZE=10px]Awhile back I did one with a really simmilar shape (bit bigger) in my 2000 Blazer...[/SIZE] [SIZE=10px] [/SIZE] [SIZE=10px]I took three peices of real thin cardboard or poster board ( 3 becasue of the width) and then took one sheet for each side and slowly cut out a bit at a time till it fit the contour of the trucks interior pretty good... [/SIZE] [SIZE=10px] [/SIZE] [SIZE=10px]Once I had each side cut to an acceptable shape, I stapled all three together to make it long eough to be one big sheet... [/SIZE] [SIZE=10px] [/SIZE] [SIZE=10px]Then I put the whole thing back in for a final test fit.. When i was happy, I laid that on top of my MDF, using it as a Template, I traced it... Then I cut it out and test fit it again... I made sure the edges were sanded smooth and stretched vinyl over it and covered it....[/SIZE] [SIZE=10px] [/SIZE] [SIZE=10px]I think it came out pretty decent for an amateur...[/SIZE] [/QUOTE]

Verification