ace_800 5,000+ posts
CarAudio.com Veteran
Item(s) for Sale:
^^^
Item(s) Description/Condition:
So I don't have a current pic until I get back tomorrow. I'm either going to sell this or the Eclipse I have FS as well. It is missing one of the screw to hold the top on, but doesn't effect it obviously. There is some minor scratches on the top, I would probably rate it 7/10, I still display it in my 66 GTO. No rust, deep pitting etc. This this is long and weighs a good amount.
Specs:
Frequency Response - 5 Hz to 50 kHz +/– 1 dB
Number of Channels - 3
Watts per Channel @ 4Watts per Channel - 2 x 25 + 1 x 100
@ 2Bridged Mono - 2 x 50 + 1 x 200
Recommended Load - >2 Stereo / >4 Bridged
Distortion (THD)Measured: 20 Hz to 20 kHz at rated power, all channels driven 4 -
Signal to Noise RatioMeasured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity - > 100 dB
Damping Factor - - > 200 @ 100 Hz with 4 load
Input Sensitivity - 100 mV to 8.5 V RMS Unbalanced Source
100 mV to 17 V RMS Balanced Source
Input to Line Output Gain 0 dB +/– 20 dB - Selectable in 10 dB steps
On-Board Crossover - 12 dB per Octave "Butterworth"
Module Port(s)Power Supply - 2 – Accessory and 2 – Balanced Line
Power Supply - Fully Regulated, PWM
Operational Voltage - 11 to 15 Volts
Fusing - 50 Amp
Price:
I don't really know what to ask as there haven't been any FS in a long time, so I'm going to start at $150 obo Shipped
Item Pictures: ACTUAL PICS TOMORROW NIGHT
^^^
Item(s) Description/Condition:
So I don't have a current pic until I get back tomorrow. I'm either going to sell this or the Eclipse I have FS as well. It is missing one of the screw to hold the top on, but doesn't effect it obviously. There is some minor scratches on the top, I would probably rate it 7/10, I still display it in my 66 GTO. No rust, deep pitting etc. This this is long and weighs a good amount.
Specs:
Frequency Response - 5 Hz to 50 kHz +/– 1 dB
Number of Channels - 3
Watts per Channel @ 4Watts per Channel - 2 x 25 + 1 x 100
@ 2Bridged Mono - 2 x 50 + 1 x 200
Recommended Load - >2 Stereo / >4 Bridged
Distortion (THD)Measured: 20 Hz to 20 kHz at rated power, all channels driven 4 -
Signal to Noise RatioMeasured: A-weighted in 20 kHz noise bandwidth @ 1 volt sensitivity - > 100 dB
Damping Factor - - > 200 @ 100 Hz with 4 load
Input Sensitivity - 100 mV to 8.5 V RMS Unbalanced Source
100 mV to 17 V RMS Balanced Source
Input to Line Output Gain 0 dB +/– 20 dB - Selectable in 10 dB steps
On-Board Crossover - 12 dB per Octave "Butterworth"
Module Port(s)Power Supply - 2 – Accessory and 2 – Balanced Line
Power Supply - Fully Regulated, PWM
Operational Voltage - 11 to 15 Volts
Fusing - 50 Amp
Price:
I don't really know what to ask as there haven't been any FS in a long time, so I'm going to start at $150 obo Shipped
Item Pictures: ACTUAL PICS TOMORROW NIGHT
