Orion HCCA 2100

[MatthewR6 10+ year member]

what does this amp actually put out at 1ohms? I ask because I see people saying anywhere between 800 to 1600 watts?

ANy ideas?

thanks!

Click to read more...

 

[Johnny Drama 5,000+ posts]

1600@1ohm

 

[VisionxOrb 10+ year member]

AT least, lol I own 1 and its just rediculas, hope you have a good charging system, dual alts woundnt hurt if ur going for competition.

 

[MatthewR6 10+ year member]

So 1 15"XXX wont be underpowered? //content.invisioncic.com/y282845/emoticons/peace.gif.2db28b618ed8d1964ebbe2f5021d2c39.gif//content.invisioncic.com/y282845/emoticons/veryhappy.gif.fec4fed33b4a1279cf10bdd45a039dae.gif

 

[ashaman 10+ year member]

So 1 15"XXX wont be underpowered? QUOTE]
Hell no.

That is one of the most underrated "cheater" amps out there. 1600x1 is conservative IMO. I have personally seen it take .5 ohm burps with some other Orion subs, I forget what model.

 

[kickerlivinloud 10+ year member]

I think they can drop as low as 1/4 ohm for burps. Very powerful and very flexible amp.

Jon

 

[revrider1 5,000+ posts]

I noticed you all were talking about the orion 2100 hcca amps. I wanted to know if you could give me some advice or help. I have had 2 2100's sitting in my room for a couple of years now along with a couple of 15" extreme 3 dvc subs 8 to be exact (all old school). I had these amps running at 1/2 ohm bridged to 4 subs and it worked fine. Now my question is I dont remember how to wire these amps bridged, what wires are for what. Now the harness has the blue wire, which if I recall correct was the remote. It has a yellow, black w/yellow stripe, orange, and black w/orange stripe. Now I know I am only going to use 2 of the wires to run it bridged but I dont remember which ones. I think it was the all orange wire to positive and the black w/yellow to negative, but am not sure. I has been about 6 or 7 years since I have even touched these, since they were put away. Any help would be appreciated on how to wire these amps bridged.

 

[MatthewR6 10+ year member]

http://www.orioncaraudio.com/alley/pdfs/sxgshcca2gen.pdf

hope that helps!

matt

 

[revrider1 5,000+ posts]

Thanks, that was fairly easy. I was right about the wiring I just wanted to be sure before trying to bring these monsters back to life. Thanks again