Reply to thread

Message: <blockquote data-quote="04silverz" data-source="post: 4509697" data-attributes="member: 566113">im pretty sure about this, but its ok to run it at 8 ohms right?im abnout to hook up my eclipse aluminum dvc 4 ohm sub to hold me over til my new sub comes in. this sub is rated at 500 watts i believe so i dont want to blow it. im assuming the orion would put out somewhere around that at 8 ohms.ive never heard of running amps at higher ohm loads of damaging them but then again ive never really looked into it either. common sense says though that it would only damage it if i went below the min ohm load since its putting more stress on the amp.</blockquote>

Top