Reply to thread

Message

<blockquote data-quote="BCotrell" data-source="post: 8682263" data-attributes="member: 666314">That unit only has two sets of rca’s. And if your speakers are wired to the Pyle unit younwont be able to use both the rcas and the speaker level inputs with great result. Solutions from cheap to less cheap:-Wire the Comp set to the front speaker level inputs although the internal amp on that deck is. It likely enough for that comp set, skip the rear speakers and put the powered sub rcas into the deck rear rca’s. Should result in some sound- get a 4 channel amp with that specifically has an pre output like this below, you’ll need an amp wiring kit too though. Hopefully you have some tuning features on that powered sub. Performance may be impacted by quality of signal from receiver preouts (likely not great)[URL unfurl=&quot;true&quot;]https://www.amazon.com/dp/B07N8HPTMC/?tag=caraudiocom-20[/URL]- scrap that deck and get a new one. A pioneer single din radio without a screen perhaps. It will have thee rca preouts including a designated sub channel, better signal, and better internalAmplification for the Comp and coaxials - new deck and an amp. Those c1’s are decent speakers and outclass all your other stuff by a lot. Would be good to give em power beyond headunit power.</blockquote>

[QUOTE="BCotrell, post: 8682263, member: 666314"] That unit only has two sets of rca’s. And if your speakers are wired to the Pyle unit younwont be able to use both the rcas and the speaker level inputs with great result. Solutions from cheap to less cheap: -Wire the Comp set to the front speaker level inputs although the internal amp on that deck is. It likely enough for that comp set, skip the rear speakers and put the powered sub rcas into the deck rear rca’s. Should result in some sound - get a 4 channel amp with that specifically has an pre output like this below, you’ll need an amp wiring kit too though. Hopefully you have some tuning features on that powered sub. Performance may be impacted by quality of signal from receiver preouts (likely not great) [URL unfurl="true"]https://www.amazon.com/dp/B07N8HPTMC/?tag=caraudiocom-20[/URL] - scrap that deck and get a new one. A pioneer single din radio without a screen perhaps. It will have thee rca preouts including a designated sub channel, better signal, and better internal Amplification for the Comp and coaxials - new deck and an amp. Those c1’s are decent speakers and outclass all your other stuff by a lot. Would be good to give em power beyond headunit power. [/QUOTE]

Verification