Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
not the "normal" install.... would like opinions and some advice
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="cfox10" data-source="post: 7945246" data-attributes="member: 631530"><p>Why components in the back? just curious... any speakers up front? if not your sound stage will be all sorts of f^cked up.</p><p></p><p>Also... I wouldn't bother putting components in the back. Stick to coaxials, and components up front. Run the EQ with full frequency to your components and let the crossover do the work on that... then just run the EQ at low pass... or low pass on the amp while keeping the EQ full range.</p><p></p><p>I'm not sure how concerned you are for sound quality but a lot of people don't care for 3.5mm as an output.</p><p></p><p>/2 cents.</p></blockquote><p></p>
[QUOTE="cfox10, post: 7945246, member: 631530"] Why components in the back? just curious... any speakers up front? if not your sound stage will be all sorts of f^cked up. Also... I wouldn't bother putting components in the back. Stick to coaxials, and components up front. Run the EQ with full frequency to your components and let the crossover do the work on that... then just run the EQ at low pass... or low pass on the amp while keeping the EQ full range. I'm not sure how concerned you are for sound quality but a lot of people don't care for 3.5mm as an output. /2 cents. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
not the "normal" install.... would like opinions and some advice
Top
Menu
Home
Refresh