Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Noob RCA question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="n2audio" data-source="post: 2589610" data-attributes="member: 540940"><p>You paid $33 for (a) sub cable(s)??!</p><p></p><p>I would probably just hook your mono cable up to one of the two sub pre-outs at the HU - not using the y cable there.</p><p></p><p>The reason being - If the signal coming from the HU isn't exactly the same on each of the 2 outputs you could theoretically cause damage to the HU. The y cables would create a short between the 2 outputs. Not a good scenario IMO.</p><p></p><p>If it IS mono you don't need to run them both anyway.</p><p></p><p>If you want to use the y cable at the amp input that's fine.</p></blockquote><p></p>
[QUOTE="n2audio, post: 2589610, member: 540940"] You paid $33 for (a) sub cable(s)??! I would probably just hook your mono cable up to one of the two sub pre-outs at the HU - not using the y cable there. The reason being - If the signal coming from the HU isn't exactly the same on each of the 2 outputs you could theoretically cause damage to the HU. The y cables would create a short between the 2 outputs. Not a good scenario IMO. If it IS mono you don't need to run them both anyway. If you want to use the y cable at the amp input that's fine. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Noob RCA question
Top
Menu
What's new
Forum list
