Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Subwoofers
Noob questions - installing sub into box
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="DFW40" data-source="post: 609546" data-attributes="member: 556468"><p>Take a pencil or whatever and make a little dot through the speaker holes to mark where you will drill then remove the sepaker. If you are gentle you can drill with the speaker still there but it is more risky.</p><p></p><p>Use a drill bit that is about half the diameter of the screw</p><p></p><p>Then yes, use a hand held screwdriver to tighten them down</p><p></p><p>Wires.....just strip you wires and stick them thru the middle of this bolt and then screw the thing back down or up whichever.</p><p></p><p>Take some fill out so the speaker has a little nest....it will not make a big difference.</p></blockquote><p></p>
[QUOTE="DFW40, post: 609546, member: 556468"] Take a pencil or whatever and make a little dot through the speaker holes to mark where you will drill then remove the sepaker. If you are gentle you can drill with the speaker still there but it is more risky. Use a drill bit that is about half the diameter of the screw Then yes, use a hand held screwdriver to tighten them down Wires.....just strip you wires and stick them thru the middle of this bolt and then screw the thing back down or up whichever. Take some fill out so the speaker has a little nest....it will not make a big difference. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Subwoofers
Noob questions - installing sub into box
Top
Menu
What's new
Forum list
