Reply to thread

Message

<blockquote data-quote="hektikm6" data-source="post: 8915727" data-attributes="member: 694254">So based on the current sub amp I am running I’ve spoke to a few installers and they mentioned it is plenty to power just the one 12 I have but they advised it needs to be wired correct to have the correct output bla bla bla - below are the spec on the amp - I will open the box and see how buddy wired it and hopefully get more insight how it should be wired..<h3>Technical Specifications:</h3>Power Ratings:<ul>
<li data-xf-list-type="ul">1 ohm: 1000W x 1</li>
<li data-xf-list-type="ul">2 ohms: 850W x 1</li>
<li data-xf-list-type="ul">4 ohms: 550W x 1</li>
</ul>Frequency Response: 10Hz - 264HzLow Pass Filter: 35Hz - 250HzSubsonic Filter: 10Hz - 50HzInput Sensitivity: 6V - 0.2VSignal to Noise Ratio: &gt;95dBTotal Harmonic Distortion (T.H.D): &lt;0.1%Operating Voltage: 9V - 15.5VFuse Rating: 100ASpeaker Wire Input: Up to 12 gaugePower and Ground Input: 4 gauge</blockquote>

[QUOTE="hektikm6, post: 8915727, member: 694254"] So based on the current sub amp I am running I’ve spoke to a few installers and they mentioned it is plenty to power just the one 12 I have but they advised it needs to be wired correct to have the correct output bla bla bla - below are the spec on the amp - I will open the box and see how buddy wired it and hopefully get more insight how it should be wired.. [HEADING=2][B]Technical Specifications:[/B][/HEADING] [B]Power Ratings:[/B] [LIST] [*][B]1 ohm:[/B] 1000W x 1 [*][B]2 ohms:[/B] 850W x 1 [*][B]4 ohms:[/B] 550W x 1 [/LIST] [B]Frequency Response:[/B] 10Hz - 264Hz [B]Low Pass Filter:[/B] 35Hz - 250Hz [B]Subsonic Filter:[/B] 10Hz - 50Hz [B]Input Sensitivity:[/B] 6V - 0.2V [B]Signal to Noise Ratio:[/B] >95dB [B]Total Harmonic Distortion (T.H.D):[/B] <0.1% [B]Operating Voltage:[/B] 9V - 15.5V [B]Fuse Rating:[/B] 100A [B]Speaker Wire Input:[/B] Up to 12 gauge [B]Power and Ground Input:[/B] 4 gauge [/QUOTE]

Verification