Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Need some help, sub not working, amp in safe mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mike437" data-source="post: 5110288" data-attributes="member: 580962"><p>So I tried re-grounding the amp to a bolt behind my seat and still no luck, amp still in protect mode. I think i might have fried my amp. Tomorrow I am going to take my sub out of the box and look at it to make sure all the wires are still hooked up. I did an ohm test using a dmm and it read 3-ohms!?!? I think one of my wire is loose/not hooked up. I wired the sub to a 1-ohm load I thought... The sub is a dvc 2 and I hooked it up using this diagram: <a href="http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&amp;I=22" target="_blank">http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&amp;I=22</a></p><p></p><p>Is it possible to get the polarity wrong on this? Any help would be much appreciated.</p></blockquote><p></p>
[QUOTE="Mike437, post: 5110288, member: 580962"] So I tried re-grounding the amp to a bolt behind my seat and still no luck, amp still in protect mode. I think i might have fried my amp. Tomorrow I am going to take my sub out of the box and look at it to make sure all the wires are still hooked up. I did an ohm test using a dmm and it read 3-ohms!?!? I think one of my wire is loose/not hooked up. I wired the sub to a 1-ohm load I thought... The sub is a dvc 2 and I hooked it up using this diagram: [URL="http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=22"]http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=22[/URL] Is it possible to get the polarity wrong on this? Any help would be much appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Need some help, sub not working, amp in safe mode
Top
Menu
What's new
Forum list
