Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Need port size help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="proatv13" data-source="post: 8722193" data-attributes="member: 675982"><p>I built it for a newer T1 and it sounded really good for a sealed box. It was about 2.4 sealed. The problem is the space in the single cab truck. I can extend it forward a little bit more if needed. As far as it being a hot mess I don’t know if I would go that far. I think it’s badass and you can’t even notice it’s in the truck. I don’t want the seat to be moved forward since in 6’3” and 260lbs. It’s my work truck so I didn’t want the passanger to be uncomfortable either so that’s why I built it so tall instead of wide. Both seats go all the way back and recline all the way back. It even goes up and comes forward I need you to half then up again to use all of the space underneath that dip</p></blockquote><p></p>
[QUOTE="proatv13, post: 8722193, member: 675982"] I built it for a newer T1 and it sounded really good for a sealed box. It was about 2.4 sealed. The problem is the space in the single cab truck. I can extend it forward a little bit more if needed. As far as it being a hot mess I don’t know if I would go that far. I think it’s badass and you can’t even notice it’s in the truck. I don’t want the seat to be moved forward since in 6’3” and 260lbs. It’s my work truck so I didn’t want the passanger to be uncomfortable either so that’s why I built it so tall instead of wide. Both seats go all the way back and recline all the way back. It even goes up and comes forward I need you to half then up again to use all of the space underneath that dip [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Need port size help
Top
Menu
Home
Refresh