Reply to thread

Message

<blockquote data-quote="marcotheclepto" data-source="post: 6481422" data-attributes="member: 607651">design with 6&quot; aearo. tuned to 37. 3.2 cubes after port/sub.cut the aero 13 inches. and center it 4.5 inches from right side and bottom of box. lowest(further from back wall, and furthest from sub possible. little over 27 sq in of port area, but if you get a real aero port(with the flanges) then it will work about the same as a 54 sq in square vent. iirc someone on here has one for sale for 35 shipped.<a href="http://img145.imageshack.us/i/kickersquareaeroport37h.png/" target="_blank"><img src="http://img145.imageshack.us/img145/7669/kickersquareaeroport37h.png" alt="" class="fr-fic fr-dii fr-draggable " style="" /></a>bottom 38x18top 38x11left and right 13.5 at tallest 11 length on top 18 length on bottom. 27* angle cut. should match those lengths up well, or straight line it.front 13.5x36.5 with sub/port cutout on opposite sides.and the rear piece should be 36.5 long with a 27*angle cut on one side and a 63*angle cut on the other. these angles should make it sit flush on top and bottom.</blockquote>

[QUOTE="marcotheclepto, post: 6481422, member: 607651"] design with 6" aearo. tuned to 37. 3.2 cubes after port/sub. cut the aero 13 inches. and center it 4.5 inches from right side and bottom of box. lowest(further from back wall, and furthest from sub possible. little over 27 sq in of port area, but if you get a real aero port(with the flanges) then it will work about the same as a 54 sq in square vent. iirc someone on here has one for sale for 35 shipped. [URL="http://img145.imageshack.us/i/kickersquareaeroport37h.png/"][IMG]http://img145.imageshack.us/img145/7669/kickersquareaeroport37h.png[/IMG][/URL] bottom 38x18 top 38x11 left and right 13.5 at tallest 11 length on top 18 length on bottom. 27* angle cut. should match those lengths up well, or straight line it. front 13.5x36.5 with sub/port cutout on opposite sides. and the rear piece should be 36.5 long with a 27*angle cut on one side and a 63*angle cut on the other. these angles should make it sit flush on top and bottom. [/QUOTE]

Verification