Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Need help is it safe to bridge amp to speakers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Bigvic514" data-source="post: 8685817" data-attributes="member: 678175"><p>Hey guys I need help I'm currently running a 4 channel amp pionner 8604 (100x4) to my pioneer speakers coaxialT Ts-D68f</p><p>on a excelon Kenwood unit.Everything was install at a local shop.Been running this setup for a couple of months and sounds good but want it louder.I wanted components but it's too complicated to fit in a crown Victoria I would have to get custom pods and all that and I don't to go that route. I have to put my volume between to 25-27/35 for it to start sounding loud should I bridged it . Speaker specs are 80 watts rms 300 watt peak and if 2xbridged at 4 ohms it's 300 watts.Would that be too much even tho the gains are set low?</p></blockquote><p></p>
[QUOTE="Bigvic514, post: 8685817, member: 678175"] Hey guys I need help I'm currently running a 4 channel amp pionner 8604 (100x4) to my pioneer speakers coaxialT Ts-D68f on a excelon Kenwood unit.Everything was install at a local shop.Been running this setup for a couple of months and sounds good but want it louder.I wanted components but it's too complicated to fit in a crown Victoria I would have to get custom pods and all that and I don't to go that route. I have to put my volume between to 25-27/35 for it to start sounding loud should I bridged it . Speaker specs are 80 watts rms 300 watt peak and if 2xbridged at 4 ohms it's 300 watts.Would that be too much even tho the gains are set low? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Need help is it safe to bridge amp to speakers
Top
Menu
Home
Refresh