Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
need an expert design will pay $$
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Moe Lester" data-source="post: 5677551" data-attributes="member: 551478"><p>While it will "work", I particularly dont like the layout of the port. I am not going to go and crunch any numbers on it but i would never aim a port opening at the cone of a sub when it is that close, especially since it can easily be built not to do so. Id also build that box with a center divider. That bottom board and the port baffle will be very flimsy with no brace.</p><p></p><p>I wouldn't use the first design without a divider in the port either.</p></blockquote><p></p>
[QUOTE="Moe Lester, post: 5677551, member: 551478"] While it will "work", I particularly dont like the layout of the port. I am not going to go and crunch any numbers on it but i would never aim a port opening at the cone of a sub when it is that close, especially since it can easily be built not to do so. Id also build that box with a center divider. That bottom board and the port baffle will be very flimsy with no brace. I wouldn't use the first design without a divider in the port either. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
need an expert design will pay $$
Top
Menu
What's new
Forum list
