Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
My IB folks, do these specs work
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jroo" data-source="post: 8674697" data-attributes="member: 574112"><p>Folks, I have used sealed and bandpass but now want to give IB a try. I want to hear what it sounds like and honestly want to get my truck back. Certainly want to do this with a cheap driver to experiment and found specs of a cheap 12 inch and want to know your thoughts. Specs belowFS 24.6Qms 15.6Qes 0.86QTs 0.81Vas cu.ft. 3.606BL 10.31Xmax 11.7 mmOn paper would this work? Since a 4 ohm driver, thinking of doing two powered by the Polk PAD 2000.0 I recently picked up for 50 bucks. I believe that rates right at 500 rms in mono load.</p></blockquote><p></p>
[QUOTE="Jroo, post: 8674697, member: 574112"] Folks, I have used sealed and bandpass but now want to give IB a try. I want to hear what it sounds like and honestly want to get my truck back. Certainly want to do this with a cheap driver to experiment and found specs of a cheap 12 inch and want to know your thoughts. Specs belowFS 24.6Qms 15.6Qes 0.86QTs 0.81Vas cu.ft. 3.606BL 10.31Xmax 11.7 mmOn paper would this work? Since a 4 ohm driver, thinking of doing two powered by the Polk PAD 2000.0 I recently picked up for 50 bucks. I believe that rates right at 500 rms in mono load. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
My IB folks, do these specs work
Top
Menu
Home
Refresh