Reply to thread

Message

<blockquote data-quote="OmegaBunny" data-source="post: 7545489" data-attributes="member: 581050">I was going to do the Omega symbol but decided that since their was a large one on the box that I would do the Fj symbol on both sides.&nbsp; I messed up the one piece of Lexan so I might change it when I redo it.I used this Lexan....<a href="http://www.amazon.com/Polycarbonate-Sheet-Clear-Thick-Length/dp/B000FPC3Z0/ref=sr_1_1?ie=UTF8&amp;amp;qid=1322441980&amp;amp;sr=8-1" target="_blank">http://www.amazon.com/Polycarbonate-Sheet-Clear-Thick-Length/dp/B000FPC3Z0/ref=sr_1_1?ie=UTF8&amp;amp;qid=1322441980&amp;amp;sr=8-1</a>and these LED&#039;s...<a href="http://www.amazon.com/gp/product/B002Q93CGM/ref=oh_o01_s00_i00_details" target="_blank">http://www.amazon.com/gp/product/B002Q93CGM/ref=oh_o01_s00_i00_details</a>I used my table saw to cut it to 8&quot; x 8&quot; squares then taped it off and drew/traced the design.&nbsp; Then I used a utility knife and straight edge to cut out the design, leaving the design and removing all the excess tape.&nbsp; I used my Dremel multi-max with the sanding attachment to frost it.&nbsp; It went very quickly and I used a straight edge to get up to the tape (even if you hit the tape its okay).&nbsp; Then remove the tape and wipe it down with alcohol.&nbsp; Very easy to do.</blockquote>

[QUOTE="OmegaBunny, post: 7545489, member: 581050"] I was going to do the Omega symbol but decided that since their was a large one on the box that I would do the Fj symbol on both sides. I messed up the one piece of Lexan so I might change it when I redo it. I used this Lexan.... [URL="http://www.amazon.com/Polycarbonate-Sheet-Clear-Thick-Length/dp/B000FPC3Z0/ref=sr_1_1?ie=UTF8&qid=1322441980&sr=8-1"]http://www.amazon.com/Polycarbonate-Sheet-Clear-Thick-Length/dp/B000FPC3Z0/ref=sr_1_1?ie=UTF8&qid=1322441980&sr=8-1[/URL] and these LED's... [URL="http://www.amazon.com/gp/product/B002Q93CGM/ref=oh_o01_s00_i00_details"]http://www.amazon.com/gp/product/B002Q93CGM/ref=oh_o01_s00_i00_details[/URL] I used my table saw to cut it to 8" x 8" squares then taped it off and drew/traced the design. Then I used a utility knife and straight edge to cut out the design, leaving the design and removing all the excess tape. I used my Dremel multi-max with the sanding attachment to frost it. It went very quickly and I used a straight edge to get up to the tape (even if you hit the tape its okay). Then remove the tape and wipe it down with alcohol. Very easy to do. [/QUOTE]

Verification