Reply to thread

Message: <blockquote data-quote="Qbenjamin" data-source="post: 3036912" data-attributes="member: 573455"><p>I was originally going to use my Dremel Circle Cutter and bit #655, but that didn't work out so well.  With the Circle cutter, you have to drill a hole in the middle to mount it in, and then let the guide do the work.  Well, that was easier said than done.  That is why you see the holes in the middle.  If you notice, I did actually cut a hole in the upper part of the sub cutout, and go around as needed.</p></blockquote><p></p>

Top